Konica-Minolta bizhub 4702P
Service Mode. Service Engineer menu
Entering Invalid engine mode
This mode allows the printer to load the correct firmware code.
- Turn off the printer.
- Press and hold 3, 4, and 6 while turning on the printer.
- Release the buttons after 10 seconds.
Entering the Service Engineer (SE) menu
To access the Service Engineer (SE) menu:
- Turn on the printer.
- When the home screen appears, press * * 411 on the control panel.
General SE
This setting allows you to save a log file to a USB drive.
Enter the Service Engineer (SE) menu, and then navigate to:
General SE >Capture Logs to USB Drive
Press [OK] to navigate through the settings.
Network SE
Enter the Service Engineer (SE) menu, and then select Network SE.
Press [OK] to navigate through the settings.
Note: Use these settings as directed by the next level of support.
Top level menu | Intermediate menu |
---|---|
Print SE Menus | Print SE Menus |
History | - Print History - Mark History |
MAC | - Set Card Speed - LAA - Keep Alive |
NPAP | Print Alerts |
TCP/IP | - netstat - arp - Allow SNMP Set - MTU - Meditech Mode - RAW LPR Mode |
Wireless | Enable Wi-Fi Direct Sigma Control Agent |
Ping Test | - Ping - Ping6 |
Other Actions | - ifconfig - IPtables [Firewall Dump] - IP6tables [Firewall Dump] - IPsec Dump |