Konica-Minolta bizhub 4700i
Troubleshooting. Machine is not energized at all, Fusing heaters do not operate
Machine is not energized at all ((DCPS operation check)
Relevant electrical parts
• Base board (BASEB)
• DC power supply (DCPS)
Procedure
Step | Check item | Location | Result | Action |
---|---|---|---|---|
1 | Is a power voltage supplied across CN1-1 and 2 on DCPS? | 7-V | NO | Check wiring from power outlet to DCPU CN1. |
2 | Are the fuses on DCPS conducting? | 7-S | NO | Replace DCPU. |
3 | Is DC24 V being output to CN4-3 on DCPS? | 9-S | NO | Replace DCPU. |
4 | Is DC24 V being output to CN4-3 on DCPS? | NO | • Check the WIRING from the wall BASEB to DCPU. • Replace DCPU. • Replace BASEB. |
|
5 | The LED on BASEB is blinking? | NO | Replace BASEB. | |
6 | Is DC24 V being output to CN4-6 on DCPS? | NO | Replace DCPU. |
Fusing heaters do not operate
Relevant electrical parts
• Right door switch (SW5)
• DC power supply (DCPS)
• Base board (BASEB)
• Fusing unit
Procedure
Step | Check item | Location | Result | Action |
---|---|---|---|---|
1 | Is a power voltage supplied across CN1-1 and 2 on DCPS? During this time, the right door should be closed. | 7-V | NO | Check wiring from power outlet to DCPU to BASEB to SW3. |
2 | Is the power source voltage applied across DCPS CN6? | 8-T | YES | Replace the fusing unit. |
NO | • Replace DCPU. • Replace BASEB. |