-
Catalog
-
Sign In
-
Contacts
-
Forum
-
Eng
Konica-Minolta bizhub 454e
Troubleshooting. JAM. 11-01, 11-02, 11-40
Misfeed at tray 1 feed section
Detection timing
11-01 |
The leading edge of the paper does not unblocked the registration sensor (PS1) even after the lapse of a given period of time after the tray 1 starts to feed paper |
11-02 |
For paper fed from the tray1, due to a delay in paper arrival, loop forming in front of the registration roller is not complete before the rise timing of the registration motor (M24). |
11-40 |
For paper fed from the tray1, the image write start signal permit continues to be disabled for a predetermined period of time after the timing of the image write start signal output. |
- |
Tray 1 paper feed sensor (PS23) is turned ON when the main power switch is turned ON, a door or cover is opened and closed, or a misfeed or malfunction is reset. |
- |
In case paper position is detected as locating properly after main power switch is turned ON, door and cover are opened / closed or jam/trouble reset is done, it is regarded as paper jam at tray 1 feed section. |
Relevant parts
• Paper feed motor (M22)
• Registration motor (M24)
• Tray 1 paper feed clutch (CL3)
• Registration sensor (PS1)
• Tray 1 paper feed sensor (PS23)
• Front side board (FRB)
• Expansion control board (EXCB)
• Printer control board (PRCB)
Step |
Action |
Control signal |
Location |
1 |
Initial check items |
|
|
2 |
PS1 I/O check, sensor check |
FRB CN8-3 (ON) |
3-L |
3 |
PS23 I/O check, sensor check |
PRCB CN26-10 (ON) |
8-C |
4 |
CL3 operation check |
PRCB CN26-8 (ON) |
8-C |
5 |
M22 operation check |
EXCB CN3-5 to 8 |
22-P |
6 |
M24 operation check |
EXCB CN3-1 to 4 |
21-P |
7 |
Replace FRB |
|
|
8 |
EXCB IC4, IC5 conduction check |
|
|
9 |
Replace EXCB |
|
|
10 |
PRCB ICP5 conduction check |
|
|
11 |
Replace PRCB |
|
|