-
Catalog
-
Sign In
-
Contacts
-
Forum
-
Eng
Konica-Minolta bizhub 454e
Troubleshooting. JAM. 10-01, 10-02, 10-40
Misfeed at manual bypass feed section
Detection timing
10-01 |
The leading edge of the paper does not unblocked the registration sensor (PS1) even after the lapse of a given period of time after the manual bypass starts to feed paper. |
10-02 |
For paper fed from the manual bypass, loop forming has not been complete before a sheet enters the registration roller because the rise timing of load to perform registration is earlier than the rise timing of load to form a loop. |
10-40 |
For paper fed from the manual bypass, the image write start signal permit continues to be disabled for a predetermined period of time after the timing of the image write start signal output. |
- |
In case paper position is detected as locating properly after main power switch is turned ON, door and cover are opened / closed or jam/trouble reset is done, it is regarded as paper jam at manual bypass feed section. |
Relevant parts
• Paper feed motor (M22)
• Registration motor (M24)
• Bypass paper feed clutch (CL7)
• Bypass pick-up solenoid (SD1)
• Registration sensor (PS1)
• Front side board (FRB)
• Expansion control board (EXCB)
• Printer control board (PRCB)
Step |
Action |
Control signal |
Location |
1 |
Initial check items |
|
|
2 |
PS1 I/O check, sensor check |
FRB CN8-3 (ON) |
3-L |
3 |
CL7 operation check |
PRCB CN27-8 (ON) |
3-C |
4 |
SD1 operation check |
PRCB CN27-10 (ON) |
4-C |
5 |
M22 operation check |
EXCB CN3-5 to 8 |
22-P |
6 |
M24 operation check |
EXCB CN3-1 to 4 |
21-P |
7 |
Replace FRB |
|
|
8 |
EXCB IC4, IC5 conduction check |
|
|
9 |
Replace EXCB |
|
|
10 |
PRCB ICP5 conduction check |
|
|
11 |
Replace PRCB |
|
|