Konica-Minolta bizhub 454e
Adjustment after replacing 2
10 Replace original size detection sensor
Installation of original size sensor 1
[Service Mode] / [State Confirmation] / [Table Number] 2
11 Replace scanner motor
Scanner motor belt adjustment
12 Replace scanner home sensor
[Service Mode] / [Machine] / [Scan Area] / [Image position: Leading Edge]
13 Replace printer control board
Installing the firmware 1
[Service Mode] / [Enhanced Security] / [Engine Data Backup] / [Engine Data Reflect Mode] 2
14 Replace MFP board
Entering the machine type information 1
Installing the firmware 2
Restore (backup) data 3
[Service Mode] / [Imaging Process Adjustment] / [Gradation Adjust] 4
15 Replace SSD board
Installing the firmware.
16 Replace original glass
[Service Mode] / [Machine] / [Scan Area] / [Scanner Image Side Edge] 1
[Service Mode] / [Machine] / [Scan Area] / [Image Position: Leading Edge] 2
17 Replace hard disk
[Service Mode] / [State Confirmation] / [Memory/HDD Adj.] / [HDD Format] 1
[Service Mode] / [State Confirmation] / [Memory/HDD Adj.] / [HDD R/W Check] 2
Install Data 3
18 Replace control panel unit
Touch panel calibration 1
[Accessibility] / [Touch Panel Adjustment] 2