Konica-Minolta bizhub 40P

NOTE
• Make sure not to reveal the password of the service menu to any unauthorized person.

Procedure 1

1. Display [SERVICE MENU] on the menu screen and press the Menu/Select key.
2. [ENTER PASSWORD] message is displayed.
3. Set first digit of password with the up key ▲/down key ▼ and press the right key ►
4. Repeat the above procedures to set up to seventh digit of password.
   Enter “KMBH40P” for service password.
   NOTE
   • The service password needs to correspond to the product name.
5. Press the Menu/Select key.

Procedure 2

1. 1. Turn the power switch ON while pressing the up key.. and the Menu/Select key at the power switch OFF.
   NOTE
   • Continue to press the up key ▲ and the Menu/Select key until “INITIALIZING” message appears on the control panel.
2. When initializing is complete, the service menu appears.
   NOTE
   • Password authentication is not required before starting to operate the service menu, however, once the service menu is closed, you need to enter the password to display the service menu again.

Procedure 3

• If a service call message is on the display, perform the following steps, since the ordinary procedure may not be good for entering the service menu.

1. With the service call message on the display, hold down the Menu/Select key for 5 sec. or more.
2. Set first digit of password with the up key ▲/down key ▼ and press the right key
3. Repeat the above procedures to set up to seventh digit of password.
   Enter “KMBH40P” for service password.

Only the following menu items are, however, available if the service menu is accessed through the above steps.

- SERIAL NUMBER
- FIRMWARE VERSION
- DIAG MODE
- RESTORE PASSWORD
- SOFT SWITCH

Exiting

• Press the Cancel key.