Konica-Minolta bizhub 4050
Maintenance. Inspection guide
The purpose of this inspection guide is to aid you in identifying the intervals, based on page count, at which parts must be inspected (for visible physical damage), cleaned, or replaced. If any unsafe conditions exist, find out how serious the hazard could be and if you can continue before you correct the hazard.
As you service the machine, check for the following:
- Damaged, missing, or altered parts, especially in the area of the On/Off switch and the power supply
- Damaged, missing, or altered covers, especially in the area of the top cover and the power supply cover
- Possible safety exposure from any non-KONICA MINOLTA attachments
Use the following table to determine when specified parts should be inspected:
|
EVERY SERVICE CALL |
EVERY 100K |
EVERY 200K |
EVERY 400K |
NOTES |
---|---|---|---|---|---|
MEDIA TRAY - ALL |
|||||
Media side guides |
Inspect |
Inspect |
Inspect |
|
Check for correct positioning. |
Media end guide |
Inspect |
Inspect |
Inspect |
|
Check for correct positioning. |
Separation pad |
Inspect |
Clean |
Clean |
|
Damp cloth |
Tray lift gear assembly |
|
Inspect |
Inspect |
|
|
Separator roll assembly |
Inspect |
Inspect |
Replace |
|
Verify page count before replacing. |
MEDIA FEEDERS - ALL |
|||||
ACM pick tire |
Inspect |
Inspect |
Replace |
Replace |
Verify page count before replacing. |
MPF pick roller/separator pad |
Inspect |
Inspect |
Replace |
Clean |
Water or alcohol |
Sensor |
|
Clean |
Clean |
Clean |
Brush or blower brush |
TRANSFER ROLL |
|||||
Transfer roll |
Inspect |
Inspect |
Replace |
Replace |
|
FUSER UNIT |
|||||
Fuser unit |
Inspect |
Inspect |
Replace |
Inspect |
|
Sensor (fuser exit) |
|
Clean |
Clean |
Clean |
Blower brush |
REDRIVE ASSEMBLY |
|||||
Redrive assembly |
|
Inspect |
Replace |
|
|
ADF ASSEMBLY |
|||||
ADF separator roll |
|
|
Replace |
|
|