Konica-Minolta bizhub 4000P

Defaults

Warning—Potential Damage: Modification of the printer setting defaults causes the NVRAM space to be restored to the printer factory settings.

This setting is used by the printer to determine whether US or non-US factory default values should be used.

To change this setting:

1. From the Diagnostics menu, navigate to: Printer Setup >Defaults
2. Choose U.S. or Non-U.S.
3. Do any of the following:
   - Press [OK] to save any changes.
   - Press [X] to return to the Printer setup menu.

Page Count

The value of this setting gauges the amount of usage on the printer. The value of the Page count setting will equal the values of the Picked sides meter.

Note: The value of the setting cannot be changed.

Perm Page Count

The value of this setting indicates the total amount of pages that have been printed.

Note: The value of this setting cannot be changed.

Processor ID

This is a 16-digit hexadecimal value representing the ID of the processor on the controller card.

Engine Setting [x]

These settings are used by Engine code ECs to fix field problems. The value of [e] is any value from 1 to 16.

Edge to Edge

When set to On, this shifts all four margins (top, bottom, left, and right) to the physical edge of the page (printable area of a supported paper size).

Par S Strobe Adj

This enables the user to adjust the amount of time the strobe is sampled to determine if valid data is available on the parallel port.

Each time this value is increased by 1, the strobe is sampled 50 ns longer. Each time this value is decreased by 1, the strobe is sampled 50 ns less. When the value of this setting is 0, the factory default value is used to determine the amount of time the strobe is sampled.