-
Catalog
-
Sign In
-
Contacts
-
Forum
-
Eng
Konica-Minolta bizhub 308e
Firmware 3. USB memory. Updating
Starting the update screen
Procedure
- Turn OFF the main power switch.
- Connect the USB memory containing the firmware into the USB port on the right side of the control panel.
NOTE
▪ USB memory must be connected with the main power switch off.
- Turn the main power switch ON while pressing the Stop key.
NOTE
▪ When [Administrator Settings] -> [Security Settings] -> [USB Connection Permission setting] -> [External Memory (Service)] - > [FW Update] is set to "Restrict", a message "It is limited by the administrator." will appear, and update of the firmware cannot be executed.
▪ When [Administrator Settings] -> [Security Settings] -> [FW Update (USB) Perm. Sett.] is set to "Password Priority", it requires to input a password after confirming with the administrator.
- Firmware Update selection screen is displayed.
NOTE
▪ Unless one of the keys on the control panel is pressed, firmware is automatically updated after 30 seconds when the main power switch is turned on.
▪ Selectable items displayed change depending on equipped options, etc.
- Select the firmware data to be updated in the Firmware Update selection screen. If multiple pages is displayed in the selection screen, check all of the pages.
NOTE
▪ When a plurality of firmware is stored in a USB memory, touch [FW Data Select] to select firmware. In the data selection screen, * is added to the firmware data name in “FW00**” folder contained in the USB memory.
- Touch [Language Select].
- On the Language Select screen, select a language to be displayed on the LCD area of the control panel, then touch [Fix].
NOTE
▪ The language selected on this screen is displayed on the "Language Selection" screen of Utility.
▪ Up to 9 languages are selectable. However, Japanese and English are essential options.
- Touch [OK] to go back to the firmware update selection screen.
- Press the [START]. (At this time, the Start key starts blinking red.)
NOTE
▪ The progress ratio of each board is displayed in writing the program.
- Check that the control panel shows the message indicating that the data has been rewritten correctly ([Downloading Completed]). (The
Start key lights blue.)
NOTE
▪ Check all pages, and make sure that no item is under firmware updating (Downloading...).
- Turn OFF the main power switch.
- Remove the USB memory.
- Turn ON the main power switch.
- Call the Service Mode to the screen.
- Select the [Firmware Version].
- Make sure if the version of firmware is updated.