Konica-Minolta bizhub 20P
Service Mode. Functions Others
Drum condensation countermeasure mode
The printing spots may occur with the condensation of the surface of the drum in the high humidity environment. When the drum condensation countermeasure mode is set to ON to follow the procedure described below, you can remedy the condensation of the surface of the drum in drying by heat of the fuser unit.
Operating Procedure
- Open the front cover.
- Turn ON the power switch.
- Press the [Go] button three times or seven times. The drum condensation countermeasure mode is set to ON.
• The drum condensation countermeasure mode is set to OFF, when perform to the above operation in the state of that the drum condensation countermeasure mode is set to ON.
• You can check the ON/OFF of the drum condensation countermeasure mode by the number of times for the LED blinking after performing the procedure (3). Drum condensation countermeasure mode is set to ON: blinking once Drum condensation countermeasure mode is set to OFF: blinking twice
Blinking LED
All LEDs
Print Settings
If you want to know the drum unit life or the number of printed pages, you should print out the Print Settings.
Contents overview:
The "Print Settings" is configured with three pages.
All pages have following terms in common:
* Title
* Model name
* Serial number
The setting indication is the same as the panel setting information, supporting 17 languages.
(ENG / FRE / GER / DUT / ITA / SPA / NOR / FIN / DAN / POR / SWE / CZE / POL / HUN / RUS / BUL / RUM)
The descriptions on the third page or later are indicated in English only.
Procedure to print out the printer settings
- The descriptions printed in Print Settings vary depending on the countries.
- It is also allowed you to print the print settings by pressing the [Go] button three times continuously when the front cover is closed and when the printer is in the ready mode.