Konica-Minolta bizhub 20P
Service Mode 01. How to Enter
The service mode is exclusively designed for the purpose of checks, settings and adjustments, and this function should be accessed by service personnel only. You can perform a print test and display the log information.
Procedure
- Check that the front cover is open.
- Turn ON the power switch while the [Go] button is held.
- After all LEDs on the panel are lit, only the Status LED goes out while holding down [Go] button.
- Release the [Go] button and check that all LEDs are out.
- Press the [Go] button once or twice. (If the [Go] button is pressed, the Status LED is lit. If the [Go] button is released, the LED is out.)
- Check that Toner/Drum/Paper LEDs are lighted.
- Press the [Go] button depending on the necessary number of times. Each mode starts after 2 seconds. (If the [Go] button is pressed, the Status LED is lit. If the [Go] button is released, the LED is out.)
Press the [Go] button once.
Press the [Go] button again depending on the necessary number of times after check
that Toner/Drum/Paper LEDs are lighted.
Press the [Go] button | Mode |
---|---|
Once | 9) Factory Inspection Mode |
Twice | 10) Continuous Grid Pattern Print Mode * Start printing when close the front cover. |
Three times | 11) Fixing Unit Test Print * Start printing when close the front cover. |
Four times | 12) NV-RAM Value Dump Mode * Start printing when close the front cover. |
Five times | 13) RAM Check |
Six times | 14) QA Test print * Start printing when close the front cover. |
Seven times | 15) DX setting (ON/OFF) |
Eight times | 16) Paper Size Setting (A4/Letter) |
Nine times | 8) PCB ONLY Mode |
More than Ten times | Go back to Normal State |
Press the [Go] button twice.
Press the [Go] button again depending on the necessary number of times after check that Toner/Drum/Paper LEDs are lighted.
Press the [Go] button | Mode |
---|---|
Once | 17) Printing for Maintenance * Start printing when close the front cover. |
Twice | 18) Maintenance + Test pattern with margin frame Printing (Duplex/LongBind) * Start printing when close the front cover. |
Three times | 19) Network Config Printing * Start printing when close the front cover. |
Four times | 20) Sleep Mode Setting (ON/OFF) * Check that all LEDs are lighted for one second. |
Five times | Ineffective |
Six times | Ineffective |
Seven times | 21) Developer Roller Counter Reset 3 (For the toner cartridge) * Check that all LEDs are lighted for one second. |
Eight times | 22)Fixed USB Speed Mode |
Nine times | 23) USB Speed Indication (ON/OFF) |
Ten times | 24) Sleep Mode Indication (OFF/Dimmed) |
More than 11 times | Go back to Normal State |
CAUTION
- Each mode starts 2 seconds after pressing the [Go] button.
- If the [Go] button is pressed, the Status LED is lighted. If the [Go] button is released, the LED is out.