Konica-Minolta AccurioPrint C759
Firmware 3. USB memory. Updating
Starting the update screen
NOTE
- When [Administrator] -> [Security] -> [USB port connection permission] -> [USB flash drive] -> [Firmware Update Parameters] is set to "Restrict", firmware update cannot be executed by using a USB memory.
- When the main power switch is turned on, a message "It is limited by the administrator." will appear.
- When [Administrator] -> [Security] -> [Firmware Update (USB) Permission Setting] is set to "Password Priority", it requires to input a password after confirming with the administrator.
- USB memory must be connected with the main power switch off.
Procedure
- Turn OFF the main power switch.
- Connect the USB memory containing the firmware into the USB port on the right side of the control panel.
NOTE
▪ USB memory must be connected with the main power switch off. - NOTE
▪ When [Administrator Settings] -> [Security Settings] -> [USB Connection Permission setting] -> [External Memory (Service)] -> [FW Update] is set to "Restrict", a message "It is limited by the administrator." will appear, and update of the firmware
cannot be executed.
▪ When [Administrator Settings] -> [Security Settings] -> [FW Update (USB) Perm. Sett.] is set to "Password Priority", it requires to input a password after confirming with the administrator. - Firmware Update selection screen is displayed.
NOTE
▪ Unless one of the keys on the control panel is pressed, firmware is automatically updated after 30 seconds when the main power switch is turned on.
▪ Selectable items displayed change depending on equipped options, etc. - Select the firmware data to be updated in the Firmware Update selection screen. If multiple pages is displayed in the selection screen, check all of the pages.
NOTE
▪ When a plurality of firmware is stored in a USB memory, touch [FW Data Select] to select firmware. In the data selection screen, * is added to the firmware data name in “FW0013” folder contained in the USB memory. - Touch [Language Select].
- On the Language Select screen, select a language to be displayed on the LCD area of the control panel, then touch [Fix].
NOTE
▪ The language selected on this screen is displayed on the "Language Selection" screen of Utility.
▪ Up to 9 languages are selectable. However, Japanese and English are essential options. - Touch [OK] to go back to the firmware update selection screen.
- Press the [START]. (At this time, the Start key starts blinking red.)
NOTE
▪ The progress ratio of each board is displayed in writing the program. - Check that the control panel shows the message indicating that the data has been rewritten correctly ([Downloading Completed]). (The Start key lights blue.)
NOTE
▪ Check all pages, and make sure that no item is under firmware updating (Downloading...). - Turn OFF the main power switch.
- Remove the USB memory.
- Turn ON the main power switch.
- Call the Service Mode to the screen.
- Select the [Firmware Version].
- Make sure if the version of firmware is updated.
Action when data transfer fails
• If “NG” appears on the control panel, indicating that rewriting has been unsuccessful (in which case the Start key lights up red), take the following steps.
- Perform the data rewriting procedure again.
- If the procedure is abnormally terminated, change the USB memory for a new one and try another rewriting sequence.
- If the procedure is still abnormally terminated, change the board that has caused “NG” and carry out data rewriting procedure.