HP LaserJet Pro M203
Control Panel Error Messages (M227, M230 models). Messeges 5
Memory is low. Press [OK] to continue.
Description
The product memory is almost full.
Recommended action
Press the OK button to finish the job, or touch the Cancel button to cancel the job. Break the job into smaller jobs that contain fewer pages.
NFC cable connection issue. Contact HP service. Press [OK] to continue.
Description
The Near Field Communication (NFC) cable diagnostics did not pass due to a cable issue.
Recommended action
Press OK to continue to use the device, but NFC will not be functional. Either replace the product or send to HP service.
No dial tone.
Description
The product could not detect a dial tone.
Recommended action
- Check for a dial tone on the phone line by touching the Start Fax button.
- Unplug the telephone cord from both the product and the wall and replug the cord.
- Verify that you are using the telephone cord that came with the product.
- Open the Service menu, and touch the Fax Service button. Touch the Run Fax Test button. This test verifies that the phone cord is connected to the correct port and that the phone line has a signal. The product prints a report with the results.
- Additional fax sending/receiving troubleshooting can be found in this document: HP LaserJet Pro MFP - Solve problems sending or receiving faxes (includes fax error messages)(c03491494) (in English) available in Service Access Workbench (SAW) or Channel Service Network (CSN).
No fax detected
Description
The product answered the incoming call but did not detect that a fax machine was calling.
Recommended action
- Open the Service menu, and touch the Fax Service button. Touch the Run Fax Test button. This test verifies that the phone cord is connected to the correct port and that the phone line has a signal. The product prints a report with the results.
- Additional fax sending/receiving troubleshooting can be found in this document: HP LaserJet Pro MFP - Solve problems sending or receiving faxes (includes fax error messages)(c03491494) (in English) available in Service Access Workbench (SAW) or Channel Service Network (CSN).
Non-HP supply installed.
Description
A non-HP supply has been installed.
Recommended action
No action necessary.
NOTE: If customer believes they purchased a new genuine HP supply, direct them to www.hp.com/go/ anticounterfeit to verify
NOTE: Service or repairs that are required as a result of using unsupported supplies is not covered under HP warranty.
Print failure, press [OK]. If error repeats, turn off then on.
Description
The product cannot process the page.
Recommended action
Press the OK button to continue printing the job, but output might be affected. If the error persists, turn the power off and then on. Resend the print job.