Epson WorkForce WF500
Troubleshooting. Check point for Fatal error 1
Detailed phenomenon
The Scanner Unit does not initialize when the power is turned on.
Occurrence timing, CR position
• Power on
• Anywhere
Defective unit/part name | Check point | Remedy |
---|---|---|
Scanner Motor | 1.Check if the Scanner Motor cable is connected to CN8 on the Main Board. | 1.Connect the Scanner Motor cable to CN8 on the Main Board |
2.Check if the coil resistance of the Scanner Motor is about 38 *1 or 43 *2 by using the tester. Note *1 :Manufactured by MITSUMI ELECTRIC CO., LTD. *2 :Manufactured by Oki Electric Industry Co., Ltd |
2.Replace the Scanner Motor with a new one. | |
3.Check if the Scanner Motor Connector Cable is damaged. | 3.Replace the Scanner Motor with a new one. |