Epson SureColor F6200
Troubleshooting. Other Troubles
The printer is not powered.
| Cause | Check Item | Remedy |
|---|---|---|
| The power cable is unplugged | Is the power plug connected properly? | Connect it properly. |
| The power voltage is unstable. | Is the electrical outlet overloaded sharing with any other electric equipment? | Use one electrical outlet for the printer only if possible. |
| Connection failure of the PSH BOARD | Is there any problems in the connection between the PSH BOARD and the MAIN BOARD? | Correct the problem. |
| Connection failure of the PANEL BOARD | Is there any problems in the connection between the PANEL BOARD and the MAIN BOARD? | Correct the problem. |
If any of the remedies above does not help, replace the following parts one by one.
• AC inlet
• PSH BOARD
Cannot access to the network.
| Cause | Check Item | Remedy |
|---|---|---|
| A wrong type of network cable is used. | Is a crossing cable used as the network cable? | Replace the cable with a straight cable. |
| Network cable failure | Is there any abnormalities observed on the cable? • Are the connectors firmly inserted? • Is the cable breaking? • Is the cable being bent or is there anything placed on the cable? |
Correct the problem. |
| LAN connector failure | Is the connector deformed or damaged? | Replace the MAIN BOARD. |
| The MAC address is invalid. | Rewrite the address with a correct one |
If any of the remedies above does not help, replace the MAIN-C BOARD
The printer makes a strange noise when the CR is moving.
| Cause | Check Item | Remedy |
|---|---|---|
| The tension of the CR TIMING BELT is not proper. | Correct the tension of the CR TIMING BELT. | |
| Lubrication of the CR UNIT and CR shaft is insufficient. | Does the CR UNIT move smoothly? Check it by pulling the CR TIMING BELT. |
If the unit does not move smoothly, lubricate it. |
| CR SCALE or CR ENCODER failure | 1. Is the CR SCALE damaged or contaminated? 2. Is the CR SCALE attached properly? 3. Is the CR ENCODER installed correctly? |
1. Clean the CR SCALE. 2. Reinstall the CR SCALE and CR ENCODER. 3. Replace the CR SCALE (See P.170) and CR ENCODER |
| Unexpected tension was applied to the tubes. | Is the resin film on the CR FFC attached properly? | Attach the resin film properly. |