Epson ME Office 700FW
Troubleshooting. Check point for Fatal error 1
Occurrence timing CR position
• Power on
• Anywhere
Detailed phenomenon | Defective unit/part name | Check point | Remedy |
---|---|---|---|
The Scanner Unit does not initialize when the power is turned on. | Scanner Motor | 1. Check if the Scanner Motor cable is connected to CN11 on the Main Board. | 1. Connect the Scanner Motor cable to CN11 on the Main Board. |
2. Check if the coil resistance of the Scanner Motor is about 38Ω *1 or 43Ω*2 by using the tester. Note *1: Manufactured by MITSUMI ELECTRIC CO. , LTD. *2 : Manufactured by Oki Electric Industry Co., Ltd. |
2. Replace the Scanner Motor with a new one. | ||
3. Check if the Scanner Motor Connector Cable is damaged. | 3. Replace the Scanner Motor with a new one. | ||
The Scanner Unit does not initialize when the power is turned on. | Scanner Carriage FFC | 1. Check if the Scanner Carriage FFC is connected to CN17 on the Main Board. | 1. Connect the Scanner Carriage FFC to CN17 on the Main Board. |
2. Check if the Scanner Carriage FFC is damaged. | 2. Replace the Scanner Carriage FFC with a new one. | ||
Scanner Carriage Unit | 1. Check if the Scanner Carriage Unit is damaged. | 1. Replace the Scanner Carriage Unit with a new one. | |
When turning on the power, the CR Motor does not operate at all. | CR Motor | 1. Check if the CR Motor Connector Cable is connected to CN9 on the Main Board. | 1. Connect the CR Motor Connector Cable to CN9 on the Main Board. |
2. Check if the CR Motor Connector Cable is not damaged. | 2. Replace the CR Motor with a new one. | ||
3. Check if the CR Motor operates. | 3. Replace the CR Motor with a new one. | ||
When turning on the power, the PF Motor does not operate at all | PF Motor | 1. Check if the PF Motor Connector Cable is connected to CN10 on the Main Board. | 1. Connect the PF Motor Connector Cable to CN10 on the Main Board. |
2. Check if the PF Motor Connector Cable is not damaged. | 2. Replace the PF Motor with a new one. | ||
3. Check if the PF Motor operates. | 3. Replace the PF Motor with a new one. |