| Occurrence Timing |
Phenomenon Detail |
Faulty Part/ Part Name |
Check Point |
Remedy |
| At power-on |
The printer does not operate at all. |
Panel FFC |
1. Check that the Panel FFC is connected to the Panel Board connector and Main Board connector CN4. |
1. Connect the Panel FFC to the Panel Board and Main Board connectors. |
| 2. Check the Panel FFC for damages. |
2. Replace the Panel FFC with a new one. |
| Panel Board |
1. Check the Panel Board for damages. |
1. Replace the Panel Board with a new one. |
| Power Supply Board |
1. Check that the connector cable of the Power Supply Board is connected to the Main Board connector CN60. |
1. Connect the connector cable of the Power Supply Board to the Main Board connector CN60. |
| 2. Check that the blue colored pin of the Power Supply Board connector cable is inserted into the 1 Pin of the Main Board connector CN60 as shown in the above picture. |
2. Reconnect the Power Supply Board connector cable so that the blue colored pin is inserted into the 1 Pin. |
| 3. Check that the Fuse F1 on the Power Supply Board has not blown. |
3. Replace the Power Supply Board with a new one. |
| 4. Check the components on the Power Supply Board for damage. |
4. Replace the Power Supply Board with a new one. |
| At operation |
Operation at power-on is normal, but the error appears when the print job is sent to the printer. |
Interface cable |
1. Check that the Interface cable is connected between the PC and printer. |
1. Connect the Interface cable to the PC and printer. |
| 2. Check the Interface cable for breaking. |
2. Replace the Interface cable with a new one. |
| USB |
1. Check that the PC and printer are connected via the USB hub. |
1. Configure the USB ID setting. |
| Printer Driver |
1. Check that the printer driver for WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100 has already been installed. |
1. Install the printer driver for WorkForce 1100/ Epson Stylus Office T1110/B1100/T1100/ Epson ME Office 1100. |
| 2. Check that the connected printer is WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100. |
2. Connect the WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100 printer. |
| Main Board |
1. Check that a wrong model name has not been input to the EEPROM on the Main Board. |
1. Make the initial setting using the Adjustment Program. |