Canon imageRUNNER Advance DX C7770i

Check that each image position is within the specified range in accordance with check procedure. If it is out of the specified range, make an adjustment in accordance with adjustment procedure for each item.

Adjustment Procedure

CAUTION:

• The test print used for adjustment must be magenta halftone image.
• In the case of 2-sided output, the first side is printed on the lower side and the second side is printed on the upper side.
• In the case of halftone images delivered face-down, the leading edge of the formed image comes to the trailing edge side with respect to the feed direction at the time of output. Be sure to pay attention to the leading edge and the trailing edge during measurement.

1. Set the service mode as follows and output the test print.
   1st side> Each paper source
   COPIER > TEST > PG > TYPE = 5
   COPIER > TEST > PG > COLOR-M = 1
   COPIER > TEST > PG > COLOR-Y = 0
   COPIER > TEST > PG > COLOR-C = 0
   COPIER > TEST > PG > COLOR-Bk = 0
   COPIER > TEST > PG > PG-PICK = 1/2/3/4/5
   COPIER > TEST > PG > 2-SIDE = 0
   2nd side> Cassette 3
   COPIER > TEST > PG > TYPE = 5
   COPIER > TEST > PG > COLOR-M = 1
   COPIER > TEST > PG > COLOR-Y = 0
   COPIER > TEST > PG > COLOR-C = 0
   COPIER > TEST > PG > COLOR-Bk = 0
   COPIER > TEST > PG > PG-PICK = 3
   COPIER > TEST > PG > 2-SIDE = 1
2. Check that the output image meets the standard.
3. If outside of standard, perform the adjustment by following the adjustment step for each item.