Canon imageRUNNER Advance C5550i

Type	Overview of detection	Check items (in arbitrary order)
Delay	A delay jam occurs when a sensor was not turned ON although a specified period of time had passed after the start of detection by the sensor.	Remaining paper at the upstream of the target sensor Soiling on the target sensor Displacement of the target sensor position Failure of the target sensor Soiling (grease)/deterioration/failure of a drive motor located upstream of the target sensor Soiling (paper dust)/deterioration/failure of a drive roller lo- cated upstream of the target sensor
Stationary	A stationary jam occurs when a sensor was not turned OFF although a specified period of time had passed after the sensor was turned ON.	Remaining paper near the target sensor Soiling on the target sensor Displacement of the target sensor position Failure of the target sensor Soiling (grease)/deterioration/failure of a drive motor located upstream of the target sensor Soiling (paper dust)/deterioration/failure of a drive roller lo- cated upstream of the target sensor
Door open	A door open jam occurs when a sensor detected door open during printing operation.	Door open during printing
Sequence	A sequence jam occurs when there was an error in sensor detection signal at printing operation se- quence. Since the jam may occur due to sporadic noise with software of each equipment or communication line (interruption of communication), failure of the part is not the cause of the jam. After the jam is removed, the machine works.	Opening/closing of the door Turning OFF and then ON the power Error near the target sensor (soiling/displacement/failure of the sensor, error in harness/open circuit of harness, soiling (grease)/deterioration/failure of a drive motor, or soiling (pa- per dust)/deterioration/failure of a drive roller)
Power-on	A power-on jam occurs when a sensor detected ON state at power-on.	Remaining paper in the machine Soiling on the target sensor Failure of the target sensor Foreign matter on the target sensor (paper dust, paper lint)
Error avoidance	An error avoidance jam occurs when an error in the machine (excluding parts failure) was detected. Printing operation is suspended to avoid error oc- currence by error code; therefore, parts failure is not the cause of the jam. After the jam is removed, the machine works. If it is due to parts failure, an error code instead of the error avoidance jam is displayed on UI and printing operation is suspended. In such case, serv- ice technician should perform remedial work for the error code.	Opening/closing of the door after jam removal Turning OFF and then ON the power after jam removal
Size error	A size error jam occurs when the difference be- tween the paper length detected by the Cassette Guide Plate/specified on the Control Panel and the length measured by the Registration Sensor is out of the specified range.	Difference in paper size Wrong paper size setting Error in the Document Size Sensor (soiling/displacement/ failure of the sensor) Error in the Paper Size Detection Unit (failure of mechanical structure for size detection, failure of the Guide Plate, or fail- ure of the Cassette Size Switch)
Forcible stop of paper feed	It occurs when a sheet of paper stops at the position specified in service mode.	Using at problem analysis.

Jam screen display specification

Due to one jam code being used for multiple options, the illustration for the different option may be displayed on the jam screen.
In this case, "1/2" or similar information is displayed on top left side of the screen and this area can be pushed. This operation
can be used to switch information on the screen.