Canon imageRUNNER Advance C475 III

Overview

The following test print types are available with this machine, and you can check for failure of an image with a circle 'Yes' described in the image check items in the table below. When no failure is found in the test print in normal output mode, it can be caused in PDL input or Reader. The image of the test print is generated by the Main Controller PCB.

Steps to Select a Test Print Type

1. Set the number of sheets, paper size, etc. in the following service mode.
   COPIER > TEST > PG > PG-PICK: Setting of the test print paper source
   COPIER > TEST > PG > 2-SIDE: Setting of the duplex mode of PG
   COPIER > TEST > PG > PG-QTY: Setting of the number of PG sheets
2. Select COPIER > TEST > PG > TYPE, enter the TYPE number of the test print to be output using the numeric keypad, and then press the OK key.
3. Select the color to be output from the following service mode items, enter 1 using the numeric keypad, and then press the OK key.
   COPIER > TEST > PG > COLOR-Y: Y
   COPIER > TEST > PG > COLOR-M: M
   COPIER > TEST > PG > COLOR-C: C
   COPIER > TEST > PG > COLOR-K: Bk
4. When the TYPE is set to "5" in step 2, specify the density in the following service mode.
   COPIER > TEST > PG > DENS--Y: Y
   COPIER > TEST > PG > DENS--M: M
   COPIER > TEST > PG > DENS--C: C
   COPIER > TEST > PG > DENS--K: Bk
5. Press start key.