Canon imageRUNNER Advance C3520i
Troubleshooting. Jam Codes. Cassette Feeding Unit-AP1
Cassette Feeding Unit-AP1
| ACC ID | Jam Code | Type | Sensor Name | Sensor ID |
|---|---|---|---|---|
| 00 | 0103 | DELAY | Cassette 3 Vertical Path Sensor | PS101 |
| 00 | 0104 | DELAY | Cassette 4 Vertical Path Sensor | PS106 |
| 00 | 0A03 | POWER ON | Cassette 3 Vertical Path Sensor | PS101 |
| 00 | 0A04 | POWER ON | Cassette 4 Vertical Path Sensor | PS106 |
Inner Finisher-K1
| ACC ID | Jam Code | Type | Sensor Name | Sensor ID |
|---|---|---|---|---|
| 02 | 1001 | DELAY | Delivery sensor | PS1 |
| 02 | 1101 | STNRY | Delivery sensor | PS1 |
| 02 | 1200 | OTHER | Timing error | - |
| 02 | 1300 | POWER ON | Delivery sensor | PS1 |
| 02 | 1400 | COVER OP | Front cover switch | MSW1 |
| 02 | 1500 | STAPLE | - | - |
| 02 | 1701 | OTHER | Delivery sensor | PS1 |
| 02 | 1801 | ERROR | Staple free stapling jam (Clinch motor drive detection sensor error) | - |
| 02 | 1802 | ERROR | Staple free stapling jam (Clinch rotation detection sensor error) | - |
| 02 | 1803 | ERROR | Staple free stapling jam (Clinch motor error) | - |
| 02 | 1804 | ERROR | Staple free stapling jam (Staple operation time out error) | - |
| 02 | 1805 | ERROR | Staple free stapling jam (Return operation time out error after sta- pling) | - |
| 02 | 1C14 | ERROR*1 | Error avoidance jam (assist motor error) | - |
| 02 | 1C16 | ERROR*1 | Error avoidance jam (paddle motor error) | - |
| 02 | 1C30 | ERROR*1 | Error avoidance jam (rear alignment motor error) | - |
| 02 | 1C32 | ERROR*1 | Error avoidance jam (stapler motor error) | - |
| 02 | 1C35 | ERROR*1 | Error avoidance jam (return belt motor error) | - |
| 02 | 1C37 | ERROR*1 | Error avoidance jam (front alignment motor error) | - |
| 02 | 1C40 | ERROR*1 | Error avoidance jam (tray shift motor error) | - |
| 02 | 1C77 | ERROR*1 | Error avoidance jam (paddle motor error) | - |
| 02 | 1F01 | OTHER | Paper feed cancel jam | - |
| 02 | 1F32 | OTHER | Manual stack insertion jam | - |
| 02 | 1F90 | OTHER | Time out jam | - |
*1: The state is recovered by opening and closing the Door, or turning OFF and then ON the power supply.