Canon imageRUNNER Advance 8585i

Location

ETB

Cause

Lines occur on the image due to shock when distortion on the belt is released while rotation speed between the ETB and drum differs

Condition

When replacing the ETB

Field Remedy

1. Output a halftone image with the following conditions and check the output image
   COPIER > TEST > PG > TYPE 6
   COPIER > TEST > PG > PG-PICK A3 (LDR)
   Select the cassette which the following paper is set:or larger.
   Image with a line on the trailing edge: Go to step 2.
   Image without a line on the trailing edge: End
2. Measure the distance from the trailing edge of the image with a line.
3. Use the following service mode to make an adjustment.
   • Adjust the Transfer Belt speed
   COPIER > ADJUST > FEED-ADJ > TBLT-SPD
   A line on the image is located approx. 55mm from the trailing edge: Adjust the value by +10 gradually.
   A line on the image is located approx. 63mm from the trailing edge: Adjust the value by -10 gradually.
4. Output a halftone image with the condition described in step 1 again and check the image.
   Image with a line on the trailing edge: Go to step 3.
   Image without a line on the trailing edge: End