Canon imageRUNNER 1643i

Engine Test Print

This machine has an engine test print function to check whether the printer engine is operating normally.

NOTE:
In the case of engine test print, a test print can be performed by using only the DC Controller.

1. Load A4/LTR paper in the Cassette or Multi-purpose Tray.

2. Press the test print switch on the PCB using a thin screwdriver through the hole on the rear of the host machine.

3. An engine test print is executed, and the test pattern as shown below is printed.

Controller test print

The following test print types are available with this machine, and you can check for failure of an image with a circle 'Yes' described in the image check items in the table below. When no failure is found in the test print in normal output mode, it can be caused in PDL input or Reader. The image of the test print is generated by the Main Controller PCB.

Follow the procedure shown below to output the test print.

1. Select the following service mode.
   TESTMODE > PRINT > PG-TYPE
2. Enter the PG number using the numeric keypad, and press the [Apply] key.
   NOTE:
   If necessary, change the settings for test print in the following service mode.
   If the settings are not changed, a test print will be executed with the initial values of service mode settings.
   • Setting of the number of output sheets:
   TESTMODE > PRINT > COUNT
   • Setting of 1-sided/2-sided printing:
   TESTMODE > PRINT > PHASE
   • Setting of the image formation method:
   TESTMODE > PRINT > MODE
   • Setting of the image correction table:
   TESTMODE > PRINT > THRU
   • Adjustment of test print density:
   TESTMODE > PRINT > DENS
   • Setting of toner thinning process:
   TESTMODE > PRINT > MABK
   • Setting of the paper source used when outputting a test print:
   TESTMODE > PRINT > FEED
3. Execute the following service mode to output a test print.
   TESTMODE > PRINT > START