Canon iR6075
Troubleshooting. Alarm Code 4
Alarm Code |
Title | A. movement /B. cause /C. measures |
---|---|---|
31-0008 | HDD failure prediction alarm | Movement: HDD failure is expected to occur in a short time due to occurrence of physical error in HDD. It does not occur in the HDD of mirroring configuration. Cause: Error in the S.M.A.R.T. value of HDD Measures:
Technology): Self-diagnosis function built in the HDD. The occurrence rate of reading error, reading and writing speed, the total number of Motor start-up and stop times, the total length of power-on time, etc. are monitored. |
32-0002 | Potential control (VL control) error | Movement: Not reflecting the result of VL control. To the laser power determined with VL control, the power with which the previous potential control was succeeded (within target potential +/-10V) is applied. Cause: The measured value in the dark area (VL) differs over +/-10V but less than +/-30V than the target potential at potential control. Measures: If there is no influence on image, measures are not needed. If not, execute the following measures.
Replace the parts.
|
Alarm Code |
Title | A. movement /B. cause /C. measures |
33-0001 | Delivery Assembly Decurler Fan alarm | Movement: No change. Cause: Connector disconnection of the Paper Cooling Fan (FM5). Failure of the Paper Cooling Fan (FM5). Measures: Check the connector -> Replace the Paper Cooling Fan (FM5). |
33-0002 | Feed Fan alarm | Movement: No change. Cause: Connector disconnection of the Registration Motor/ Duplex Motor Cooling Fan (FM42). Failure of the Registration Motor/Duplex Motor Cooling Fan (FM42). Measures: Check the connector -> Replace the Registration Motor/Duplex Motor Cooling Fan (FM42). |
33-0010 | Stream Reading Fan alarm | Movement: Nothing in particular (Fan stops). Cause: The Fan rotation signal cannot be detected after 3 seconds have passed since the Scanner Unit Heat Exhaust Fan (FM1) is turned ON. Measures: Check the connector connection -> Replace the Scanner Unit Heat Exhaust Fan (FM1). |
33-0013 | Power Unit Fan 1 alarm | Movement: No change. Cause: Connector disconnection of the Feed Driver Cooling Fan (FM40). Failure of the Feed Driver Cooling Fan (FM40). Measures: Check the connector -> Replace the Feed Driver Cooling Fan (FM40). |
33-0022 | Read Motor Cooling Fan alarm | Movement: Nothing in particular (Fan stops). Cause: The Fan rotation signal cannot be detected after 3 seconds have passed since the Motor Driver Cooling Fan (FM1) or the Read Motor Cooling Fan (FM2) is turned ON. Measures: Check the connector connection -> Replace the Motor Driver Cooling Fan (FM1) or the Read Motor Cooling Fan (FM2). |
33-0023 | Scanner Unit (DADF) Cooling Fan alarm | Movement: Nothing in particular (Fan stops). Cause: The Fan rotation signal cannot be detected after 3 seconds have passed since the (DADF) Scanner Unit Cooling Fan (FM3) is turned ON. Measures: Check the connector connection -> Replace the DADF Scanner Unit Cooling Fan (FM3). |
33-0025 | Scanner Unit (Reader) Cooling Fan alarm | Movement: Nothing in particular (Fan stops). Cause: The Fan rotation signal cannot be detected after 3 seconds have passed since the (Reader) Scanner Unit Cooling Fan (FM2) is turned ON. Measures: Check the connector connection -> Replace the (Reader) Scanner Unit Cooling Fan (FM2). |