Canon i-SENSYS MF227dw
Service Mode. TESTMODE. SYSTEM, SCAN
SYSTEM
DRAM
| TESTMODE > SYSTEM > DRAM | ||
|---|---|---|
| Sub item | Description | Common to all models |
| TEST1 | Data read/write check for DRAM (except system work area) | Yes |
SPEAKER
| TESTMODE > SYSTEM > SPEAKER | |||
|---|---|---|---|
| Sub item | Description | FAX model |
Other model |
| ON | When "ON" is selected, entry tone is generated once. | Yes | No |
| MIN | When "MIN" is selected, entry tone is generated once. | Yes | No |
| MAX | When "MAX" is selected, entry tone is generated once. | Yes | No |
SCAN
ADJUST
ADF-ADJ
| TESTMODE > SCAN > ADJUST > ADF-ADJ | |||
|---|---|---|---|
| Sub item | Description | ADF model |
Other model |
| DF-SPEED | Enter the adjustment value for the magnification ratio in vertical scanning direction in stream feeding Setting value: -30 ~ 30(Default value: 0) |
Yes | No |
| DF-OFFSET | Enter for the adjustment of DF original stop position Setting value: -30 ~ 30(Default value: 0) | Yes | No |
SENSOR
| TESTMODE > SCAN > ADJUST > SENSOR | ||
|---|---|---|
| Sub item | Description | Common to all models |
| TRAY PAPER SENSOR | Display the status of Multi Pickup Sensor 1: Paper existing 0: No paper | Yes |
| REGI SENS | Display the status of Leading Edge Sensor 1: Paper existing 0: No paper | Yes |
| ESS DOOR SENS | Display the status of Delivery Tray Open/ Close Switch 1: OPEN 0: CLOSE | Yes |
ADFTEST
| TESTMODE > SCAN > ADFTEST | ||||
|---|---|---|---|---|
| Sub item | Description | SADF model |
DADF model |
Other model |
| SPEED | For testing of ADF feeding speed. Execute feeding test of ADF motor at specified speed. [Setting value] STDFAX, FINEFAX, SFINEFAX, RGB300dpi, RGB150dpi, Gray300dpi, Gray150dpi, Mono300dpi, Mono150dpi |
Yes | Yes | No |
| 2-SIDE | Specify ON/OFF for duplex mode | No | Yes | No |
| COUNT | Page counter for originals: Existing | Yes | Yes | No |
| START | Start feeding | Yes | Yes | No |
BOOKFEED
| TESTMODE > SCAN > BOOKFEED | |||
|---|---|---|---|
| Sub item | Description | Common to all models |
|
| PAGE | Display the number of bookfeed pages | Yes | |
| SPEED | For testing of feeding speed. Execute feeding test of the book motor at specified speed. [Setting value] STDFAX, FINEFAX, SFINEFAX, RGB600dpi, RGB300dpi, RGB150dpi, Gray600dpi, Gray300dpi, Gray150dpi, Mono600dpi, Mono300dpi, Mono150dpi |
Yes | |
| START | Start of bookfeed | Yes | |
| STOP | End of bookfeed | Yes | |