Brother MFC-L8600CDW

User Check

- Check if the paper is loaded into the paper tray correctly.
- Check that too much paper is not loaded in the paper tray.
- Turn back the paper loaded in the paper tray or change the orientation of the paper by 180°.
- Check if the thickness of the paper is 60 to 105 g/m2.
- Check whether the MP tray or paper tray 1 is specified for the paper feeding tray.
- Fan the stack of paper well and reinsert the papers into the paper tray.
- Clean the T2 paper pick-up roller.
- Check whether the paper tray 1 is closed correctly.

Step	Cause	Remedy
1	T2 paper feed actuator coming off	Re-assemble the T2 paper feed actuator.
2	Connection failure of the main motor harness	Reconnect the main motor harness.
3	T2 roller holder ASSY installation failure	Install the T2 roller holder ASSY correctly.
4	Connection failure of the T2 paper feed/plate origin sensor PCB harness	Reconnect the T2 paper feed/plate origin sensor PCB harness.
5	Connection failure of the T2 registration sensor PCB harness	Reconnect the T2 registration sensor PCB harness.
6	Connection failure of the T2 relay PCB harness	Reconnect the T2 relay PCB harness.
7	T2 paper pick-up roller worn out	Replace the PF kit 2.
8	T2 relay PCB failure	Replace the T2 relay PCB ASSY.
9	Main motor failure	Replace the process drive unit.
10	Paper feed related gear damaged	Replace the main drive unit.
11	Fuser unit damaged	Replace the fuser unit.
12	Main PCB failure	Replace the main PCB ASSY.
13	T2 connector or T2 plate motor failure	Replace the T2 paper tray unit.