Brother HL-L3290CDW

To identify machines connected via USB direct interface, the computer requires the corresponding driver for the virtual USB device. If you connect any number of machines to your computer, the same number of virtual USB devices will be automatically configured on your computer. To prevent many virtual USB devices from being configured, use the unique driver installation procedure described below that enables your computer to identify terminals via one single virtual USB device.

Note:

• Once this installation procedure is carried out for a computer, no more driver/software installation will be required for that computer to identify machines. If the Brother Maintenance USB Printer driver has been already installed to your computer according to this procedure, skip this section
• Before proceeding to the procedure given below, make sure that the Brother Maintenance USB Printer driver is stored in your computer.

Windows 7/Windows 8/Windows 8.1/Windows 10

1. Check that the AC cord of the machine is unplugged from the electrical outlet. Disconnect the USB cable that connects the machine with your computer.
2. Turn ON your computer.
3. Double-click Setup.exe inside the Brother Maintenance USB Printer folder that was saved in a temporary folder. The following screen appears. Click the [Next] button. The following screen is displayed during installation.
4. Wait for the following screen to appear and click [Finish].
5. Plug the AC cord of the machine into an electrical outlet.
6. Enter the maintenance mode.
7. Connect the machine to your computer using a USB cable and the installation will be performed automatically.