Brother HL-L3230CDN
Troubleshooting. 2.1 No paper feeding from T1
User Check
• Check that the paper is set in the T1 correctly.
• Check that there is not too much paper set in the T1.
• Flip over the paper in the T1 or rotate the paper 180°.
• Check that the thickness of the paper is 60 to 163 g/m2.
• Check if the paper feeding from the T1 is set.
• Flip through the paper and reset it in the T1.
• Clean the T1 pick-up roller.
Step | Cause | Cause |
---|---|---|
1 | Dirt on the paper dust cleaning roller of the T1 | Refer to the figure below to clean the paper dust cleaning roller and inside of the paper dust cleaning roller cover. |
2 | T1 roller holder ASSY attachment failure | Reattach the T1 roller holder ASSY correctly. |
3 | Connection failure of the T1 paper empty/paper feed sensor harness | Reconnect the T1 paper empty/paper feed sensor harness. |
4 | Abrasion of the T1 pick-up roller | Replace the PF kit 1. |
5 | Damaged gears in the paper feed drive unit | Replace the paper feed drive unit. |
6 | Paper feed motor failure | Replace the process drive unit. |
7 | Paper feed unit failure | Replace the paper feed unit. |
8 | Damaged fuser unit | Replace the fuser unit. |
9 | Main PCB failure | Replace the main PCB. |