Brother DCP1610W

 

Function code	Function
01	Initialize EEPROM parameters
05	Print white level / black level data for document scanning compensation
06	Move CIS unit to transportation position
08	ADF performance test
09	Monochrome image quality test pattern
10	Set worker switches (WSW)
11	Print worker switch (WSW) setting data
12	Check LCD operation
13	Check control panel button operation
25	Display software version
32	Check sensor operation
33	Display LAN connection status
43	Set PC print functions
45	Change USB No. return value
52	Set country / language
53	Transfer received fax data / log information
54	Fine-tune scanning position
55	Acquire white level data and set CIS scan area
67	Print test
69	Print frame pattern (single-side printing)
71	Print test pattern
74	Setting by country
77	Print maintenance information
78	Operational check of fans
80	Display machine log information
82	Display machine error code
87	Send communication log information to telephone line
88	Reset irregular power supply detection counter of low- voltage power supply PCB
91	Initialize EEPROM parameters
99	Quit maintenance mode

The maintenance mode functions shaded in the table can be used by end users.

Initialize EEPROM parameters (Function code 01, 91)

This function is used to initialize the setting values for operation parameters, user switches, and worker switches (WSW) registered in the EEPROM. Entering function code 01 initializes most EEPROM areas. Entering function code 91 initializes only the specified areas as shown in the table below.

Operating Procedure

1. Press the [0], and then the [1] (or press the [9], and then the [1] as required) in the initial state of maintenance mode. For models without keypad, press the [▲] or [▼] to display “MAINTENANCE 01” (or “MAINTENANCE 91” as needed) on the LCD and press the [OK]. “PARAMETER INIT” is displayed on the LCD.
2. When initializing parameters is completed, the machine returns to the initial state of maintenance mode.

Note: Function code 01 is for service personnel. Function code 91 is for user support.