Brother DCP-T510W

Worker switch setting (Maintenance mode 10)

Function

The worker switch functions customize the machine to meet various needs. They can be activated with the procedures using the control panel keys. The worker switches have been configured at the factory in conformity to the communications standards and codes of each country. Do not disturb them unless necessary.

* For details about the worker switches, refer to the document separately issued.

Operating Procedure

1. Press the 1 and 0 keys in this order in the initial stage of the maintenance mode. The machine displays the "WSW00" on the LCD.
2. Enter a worker switch number to be modified. The following appears on the LCD:
   WSWXX = 0 0 0 0 0 0 0 0
3. Press the ◄ ► key to move the cursor to the selector position to be modified.
   Press the 0 or 1 key to change the setting.
4. Press the SET key. This operation saves the newly entered selector values onto the EEPROM and readies the machine for accepting a worker switch number ("WSW00").
5. When all the switches are entered, press the X key to return the machine to the initial stage of the maintenance mode.

Notes:

• To cancel the setting and return to the initial stage of the maintenance mode, press the X key.
• If there is a pause of more than one minute after a single-digit number is entered for double-digit worker switch numbers, the machine automatically returns to the initial stage of the maintenance mode.