Brother DCP-T510W

The maintenance mode is exclusively designed for the purpose of checks, settings and adjustments of the machine and can be triggered by the keys on the control panel. In the maintenance mode, you can perform operational checks of sensors, perform a print test, display the log information or error codes, and configure worker switches (WSW).

How to Enter the Maintenance Mode for Service Personnel

Touch panel model

Operating Procedure

1. When the machine is on standby, hold down the Home key for approx. 5 seconds to display the following screen on the LCD.
2. Press the blank area at the bottom of the LCD to display the following screen.
3. Press the *, 2, 8, 6 and 4 keys on the LCD in this order. The machine displays the following screen on the LCD and enters the maintenance mode.
4. To select one of the maintenance mode functions, enter the corresponding 2-digit code using the numerical keys.

Non-touch panel model with numerical keys

Operating Procedure

1. When the machine is on standby, press the Menu and Mono Start or Black Start keys in order. Next, press the ▲ key 4 times. The LCD will display "■■ MAINTENANCE ■■■", and the machine will enter maintenance mode.
2. To select one of the maintenance mode functions, enter the corresponding 2-digit code.

Notes:

• Entering the 9 key twice in the initial stage of the maintenance mode switches the machine to standby
• Pressing the X or Stop/Exit key after entering only one digit returns the machine to the initial stage of the maintenance mode.
• If an invalid maintenance code is entered, the machine returns to the initial stage of the maintenance mode.

How to Enter the End User-accessible Maintenance Mode

Basically, the maintenance-mode functions should be accessed by service personnel only. However, you can allow end users to access some of these under the guidance of service personnel (e.g., by telephone).

The user-accessible functions are shaded in the table given on the 5-5 page. (Maintenance mode 10, 11, 12, 28, 37*, 46, 53, 54, 56, 58, 65, 66, 75, 76, 77, 80, 82, 87, 88, 91)

Touch panel model

Operating Procedure

1. When the machine is on standby, hold down the Home key for approx. 5 seconds to display the following screen on the LCD
2. Press the blank area at the bottom of the LCD to display the following screen.
3. Press the *, 0 and # keys on the LCD in this order. The machine becomes ready to accept entry from the keys. Enter the desired maintenance code.
4. When each of the maintenance mode functions is completed, the machine automatically returns to standby.

Non-touch panel model with numerical keys

Operating Procedure

1. When the machine is on standby, press the Settings or Menu, *, 0 and # keys in this order. The machine becomes ready to accept entry from the keys. Enter the desired maintenance code.
2. When each of the maintenance mode functions is completed, the machine automatically returns to standby.

Non-touch panel model without numerical keys

1. When the machine is on standby, press the Menu, Mono Start, and Menu keys in this order. The machine becomes ready to accept entry from the keys. Enter the desired maintenance code.
2. When each of the maintenance mode functions is completed, the machine automatically returns to standby.

Note

To stop the procedure midway and return the machine to standby, press the X or Stop/Exit key.

Operations of the Keys in the Maintenance Mode

The operations of the keys used in the maintenance mode are different depending on the panel specifications on the model.

Entering ten keys and the other keys in the maintenance mode with models without these keys

Press the ▲ or ▼ key to display desired letters on the LCD, and press the OK key to enter.