Brother DCP-J572DW

Creating of Head Calibration Data and Writing it into Flash ROM (Maintenance mode 02)

Error code	The following error has occurred.	Do the following:
01	Failed to detect the external frame.	- Clean the document cover glass. - Reset the print pattern so that the ▲ mark is aligned with the left rear of the document cover without tilt. - Check that there is no block missing. - Go back to step (2) and print out "Print pattern for creating head calibration data" again.
02	Internal image inclined.
03	Failed to detect position.
04	Failed to write head calibration data.	- Clean the document cover glass. - Reset the print pattern so that the ▲ mark is aligned with the left rear of the document cover without tilt. - Check that there is no block missing. - Restart the machine and perform the procedure from the beginning again. - Replace the main PCB.
05	The uneven printing correction function for upper and lower ends of the nozzle is disabled with Maintenance 88.	- Set selector 1 on AMS05 to "0" (ON) in “Assurance Mode Switch Setting (Maintenance mode 88)” in this chapter.
06	Cannot get data due to memory full.	- Delete fax data and other data stored in the memory. - Replace the main PCB.
07	The document scanner unit is open.	- Close the document scanner unit. - Reconnect the document scanner sensor harness. - Replace the document scanner if the boss that presses the document scanner sensor is broken. - Replace the main PCB.
09	Scanning errors other than the above.	- Use “Acquisition of White/Black Level Data (Maintenance mode 55)” in this chapter.
10	With a media being inserted, the USB cable or LAN cable is connected.	- Disconnect the USB cable or LAN cable.