Samsung CLX6260ND

• Code: M1-1610
• Display: Paper Jamin MP tray
• Description: The jammed paper has occurred in the MP tray.
• Remedy: 1) Remove the jammed paper. 2) If the jammed paper occurs continually, check the followings. a) Check if the pick up/forward/reverse roller are worn out or contaminated. Clean the contaminated part or replace it. b) Check if the actuator is assembled correctly. 3) If the pick up clutch is defective, replace it. 4) If the problem persists, replace the MP unit.

• Code: M1-5112, M1-5612
• Display: Paper Empty in Tray1 Paper Empty in MP Tray
• Description: Paper is empty in Tray1
• Remedy: 1) Take off the cassette. If there is no paper on the tray, load the paper. 2) If the problem persists, check the following. a) Check if the paper empty sensor is contaminated or defective. Replace it.

• Code: M2-1110, M2-2210
• Display: Paper Jam inside machine Paper Jam inside of duplex
• Description: The jammed paper has occurred inside machine.
• Remedy: 1) Open the rear cover. Remove the jammed paper. 2) If the problem persists, check the following. a) Check if there is any obstacles or paper on the paper path. Remove it. b) Check if the FRAME-REGI unit and FRAME-RATARD unit are assembled properly. If there is any defective part in these units, replace it or Assy. c) Check the motor operation, gear in the PH drive unit. If there is any defective parts, replace it or PH drive unit. d) Check the T1-DRIVE unit. If there is any defective parts, replace it or T1-DRIVE unit.

• Code: M3-1110
• Display: Paper Jam in exit area
• Description: The jammed paper has occurred in the exit area.
• Remedy: 1) Remove the jammed paper. 2) If the problem persists, check the following. a) Check if there is any obstacles or paper on the paper path. Remove it. b) Check if the fuser unit is assembled properly. If the fuser unit is defective, replace it. c) Check if the exit unit has any defective parts. Replace the exit unit.

• Code: M3-2130
• Display: Output bin full Remove paper
• Description: The machine detected that the output tray has got full or the bin-full sensor is defective.
• Remedy: 1) Remove the paper on the output tray. 2) Check if the Bin-full Sensor connector is connected properly. Reconnect it. 3) If the sensor is defective, replace it.

• Code: S2-1210
• Display: Error #S2-1210 Call for service
• Description: The power Micom chip on main board is not detected.
• Remedy: 1) Turn the machine off then on. 2) If the error persists, replace the main board.