Causes: 721 With the [Tape separation] function set ON, no power is supplied to the job separator when start key is pressed. 727 After cluster-A signal turned ON, BUSYsignal stayed [L] more than 7 seconds (power to job separator was turned OFF while the tape is being ejected.
Remedy: Press the <RESET> Key and check and switch ON the power of Job Separator.
Code: B23
Description: Job separator: No tape
Causes: 722 With the [Tape separation] function set ON, no tape detected in the job separator when the start key is pressed. 723 No tape remains in job separator upon completion of the tape-ejection operation.
Remedy: Press the <RESET> Key and set paper tape in Job Separator.
Code: B24
Description: Job separator: Tape jam
Causes: 724 Tape jam detected when the start key is pressed with the [Tape separation] function set to ON. 725 The tape-jam detection signal is [H] for more than 1.2 seconds after cluster-A signal turns ON (tape misdeed). 726 Job separator tape-jam detection signal is [L] when the BUSY signal changes from [L] to [H] (or after 7 sec. at [L]) after the cluster-A signal goes ON (tape misfeed).
Remedy: Press the <RESET> Key and remove the jammed tape.
Code: B25
Description: Sorter: Tray full error
Causes: 704 Sorter tray full.
Remedy: Remove papers from the Sorter tray.
Code: B26
Description: Sorter: Paper remaining on tray error
Causes: 705 Paper remaining on the Sorter tray.
Remedy: Remove paper from the Sorter tray.
Code: B27
Description: Sorter: Stapler error
Causes: 706 Stapler error command is received from the sorter.
Remedy: Check the stapler and correct the stapler problem.