Causes: 410 The Paper ejection sensor was OFF when paper should have arrived, and the Paper sensor was OFF when the machine stopped (paper jam on the print drum). 430 Paper jam on the Print drum (recovery error).
Remedy: Pull out the Print Drum. Remove the jammed paper. <Do not touch the separation hook or master removal hook when putting your hand into the unit to remove paper. The sharp tips of the hooks can hurt your hand.>
Code: A09(J)
Description: Paper-ejection error
Causes: 411 The Paper ejection sensor was ON when the paper should have left the Paper ejection sensor. 417 The Paper ejection sensor was ON at the start of machine operation when the START button was pressed. 431 The Paper ejection error (recovery error).
Remedy: Check for any jammed paper on the paper exit area. When using special paper, adjust the Paper Arranger on the Receiving Tray Paper Guides according to the paper characteristics.
Code: A10(J)
Description: AF original feed error
Causes: 102 The original is pulled out from the AF unit before the scanning is completed. 103 Original jammed at the AF registration sensor. (The AF registration sensor does not go OFF after the AF read sensor goes ON) 105 Original jammed at AF read sensor. (The AF read sensor does not go OFF after the AF registration sensor goes OFF) 106 Original jammed at AF original ejection sensor. (The AF original ejection sensor does not go OFF after the AF read sensor goes OFF) 107 The Original does not arrive to the AF registration sensor. 108 The Original does not arrive to the AF read sensor. 109 The Original does not arrive to the AF original ejection sensor. (The AF original ejection sensor does not go ON after the AF read sensor goes ON) 169 The AF feed cover is opened due to original jam, while originals are present on the tray.
Remedy: Pull the AF Original Release Lever (Option) to the right, and remove the original. Raise the Platen Cover, turn the AF Original Release Dial and remove the original.
Code: A16
Description: Awaiting for the master to be removed from the drum
Causes: 525 Waiting for the master to be removed from the Print drum.
Remedy: 1. Pull out the Print drum and remove the master from the drum. 2. Return the Print drum in place. 3. Press the [START] key.
Code: A17
Description: Cutter error
Causes: 209 The Cutter HP switch is OFF when master making starts, when the master material is set in the Master making unit.
Remedy: Pull out the Master Making Unit and remove master. Closing the Master Making Unit Cover will reset the error. Setup the master again.
Code: A34
Description: Requesting for master to be reset
Causes: 218 Requesting for the master material to be reset into the Master making unit.
Remedy: Pull out the Master Making Unit and reinstall the master. If the leading edge of the master is wrinkled or torn, cut the edge straight and reinstall.