PrintCopy.info service

Riso CZ180

Error Codes List page 1

  • Code: A01
  • Display: A01-xxx Master Mis-Feed Pull Out Master Making Unit and Rewind Master Roll, then Reset Master in Place.
  • Description: A01 [Master feed error]
  • Causes: 201 Master-positioning sensor does not go ON even after the write pulse motor is activated during the master-positioning, master-cut, or master-loading operation.
    202 Master-positioning sensor does not go OFF even when the write pulse motor is reversed during the master-positioning or at start of master-making operation.
    211 Master-positioning sensor is ON during standby.
    214 Master-positioning sensor is ON at the start of master making.
    215 Even though the Write pulse motor stopped, the pulse count did not match with the programmed pulse count
  • Code: A02
  • Display: A02-xxx Master Loading Error Pull Out Print Cylinder and Discard Master.
  • Description: A02 [Master loading error]
  • Causes: 509 Master-loading sensor was OFF when the master was checked at a specified drum angle during the master-loading operation.
  • Code: A04
  • Display: A04-xxx Master Disposal Error Pull Out Print Cylinder and Discard Master.
  • Description: A04 [Master disposal error]
  • Causes: 303 Check Print Drum - Master removal error / Master disposal jam.
  • Code: A05
  • Display: A05-xxx Master Jammed in Disposal Unit Pull Out Master Disposal Box and Remove Jammed Master
  • Description: A05 [Master present in the master disposal area]
  • Causes: 304 Master disposal box check request after master removal error or master disposal jam.
    312 Master disposal jam sensor was ON at the start of the master making.
  • Code: A07
  • Display: A07 [Paper feed error]
  • Description: A07 [Paper feed error]
  • Causes: 409 Paper-ejection sensor was OFF when the paper should have arrived, and the paper sensor was ON when the machine stopped (Paper misfeed).
    412 Paper sensor was OFF when a paper misfeed was detected (paper misfeed).
    418 The paper sensor was ON at the start of machine operation when the START button was pressed.
  • Code: A08
  • Display: A08 [Paper jam on print drum]
  • Description: A08 [Paper jam on print drum]
  • Causes: 410 Paper-ejection sensor was OFF when paper should have arrived, and the paper sensor was OFF when the machine stopped (paper jam on the print drum).
Error Code
Service Mode, Troubleshooting
Parts Catalog
Compatibility
Downloads Files
Home
New Register Forgot Password?
Send message to us