PrintCopy.info service

Ricoh SP3600SF

Error Codes List page 1

  • Code: SC101-00
  • Description: Exposure Lamp Error
  • Causes: The scanner has scanned the white plate, but cannot detect the certain white level. • Defective exposure lamp • Defective exposure lamp stabilizer • Defective power source harness • Defective signal harness • High-voltage cable leak • Defective darkness starting characteristic
  • Remedy: Turn the main power OFF and then ON.
  • Code: SC101-01
  • Description: Exposure Lamp Error
  • Causes: The scanner has scanned the white plate, but cannot detect the certain white level. • Defective exposure lamp • Defective exposure lamp stabilizer • Defective power source harness • Defective signal harness • High-voltage cable leak • Defective darkness starting characteristic
  • Remedy: Turn the main power OFF and then ON.
  • Code: SC120
  • Description: Scanner home position error 1
  • Causes: The scanner home position sensor does not detect the scanner leaving the home position. • Defective scanner home position sensor • Defective scanner home position sensor harness • Defective scanner motor driver • Defective scanner motor
  • Remedy: Turn the main power OFF and then ON.
  • Code: SC121
  • Description: Scanner home position error 2
  • Causes: The scanner home position sensor does not detect the scanner coming back to the home position. • Defective scanner home position sensor • Defective scanner home position sensor harness • Defective scanner motor driver • Defective scanner motor
  • Remedy: Turn the main power OFF and then ON.
  • Code: SC230-00
  • Description: FGATE*1 : Does not turn ON. (*1)FGATE: Signals used between the controller and the engine in order to send the information about the sub scan length of the page to be printed.
  • Causes: GPIO*2 has not been asserted, although the specified time (200 ms) elapsed after setting JOB to be started and reaching the FGAT assert time. • Engine board defective • ASIC defective • Controller board defective • Harness disconnection (*2)GPIO: A type of input/output terminal
  • Remedy: Turn the main power OFF and then ON.
  • Code: SC231-00
  • Description: FGATE*1: Does not turn OFF. (*1)FGATE: Signals used between the controller and the engine in order to send the information about the sub scan length of the page to be printed.
  • Causes: GPIO*2 has not been negated, although the specified time (200 ms) elapsed after detecting GPIO*assert and then reaching the expected FGATE negate time. • Engine board defective • Write ASIC defective • Controller board defective • Harness disconnection (*2)GPIO: A type of input/output terminal
  • Remedy: Turn the main power OFF and then ON.
Error Code
Service Mode, Troubleshooting
Parts Catalog
Compatibility
Downloads Files
Home
New Register Forgot Password?
Send message to us