Causes: The scanner has scanned the white plate, but cannot detect the certain white level. • Defective exposure lamp • Defective exposure lamp stabilizer • Defective power source harness • Defective signal harness • High-voltage cable leak • Defective darkness starting characteristic
Remedy: Turn the main power OFF and then ON.
Code: SC101-01
Description: Exposure Lamp Error
Causes: The scanner has scanned the white plate, but cannot detect the certain white level. • Defective exposure lamp • Defective exposure lamp stabilizer • Defective power source harness • Defective signal harness • High-voltage cable leak • Defective darkness starting characteristic
Remedy: Turn the main power OFF and then ON.
Code: SC120
Description: Scanner home position error 1
Causes: The scanner home position sensor does not detect the scanner leaving the home position. • Defective scanner home position sensor • Defective scanner home position sensor harness • Defective scanner motor driver • Defective scanner motor
Remedy: Turn the main power OFF and then ON.
Code: SC121
Description: Scanner home position error 2
Causes: The scanner home position sensor does not detect the scanner coming back to the home position. • Defective scanner home position sensor • Defective scanner home position sensor harness • Defective scanner motor driver • Defective scanner motor
Remedy: Turn the main power OFF and then ON.
Code: SC230-00
Description: FGATE*1 : Does not turn ON. (*1)FGATE: Signals used between the controller and the engine in order to send the information about the sub scan length of the page to be printed.
Causes: GPIO*2 has not been asserted, although the specified time (200 ms) elapsed after setting JOB to be started and reaching the FGAT assert time. • Engine board defective • ASIC defective • Controller board defective • Harness disconnection (*2)GPIO: A type of input/output terminal
Remedy: Turn the main power OFF and then ON.
Code: SC231-00
Description: FGATE*1: Does not turn OFF. (*1)FGATE: Signals used between the controller and the engine in order to send the information about the sub scan length of the page to be printed.
Causes: GPIO*2 has not been negated, although the specified time (200 ms) elapsed after detecting GPIO*assert and then reaching the expected FGATE negate time. • Engine board defective • Write ASIC defective • Controller board defective • Harness disconnection (*2)GPIO: A type of input/output terminal