PrintCopy.info service

Ricoh MP5002

Error Codes List page 1

  • Code: 101
  • Description: Exposure lamp error
    -001: Shading at AGC
    -002: Shading at scanning
    • The standard white level was not detected properly when scanning the white plate
  • Causes: • Exposure lamp defective • Lamp stabilizer defective • Exposure lamp connector defective • Standard white plate dirty • Scanner mirror or scanner lens out of position or dirty • SBU defective
  • Code: 120
  • Description: Scanner home position error 1
    The scanner home position sensor does not detect the “OFF” condition during initialization or copying.
  • Causes: SIB or scanner drive motor defective • Scanner motor defective • Harness between SIB and scanner drive motor disconnected • Harness between SIB and scanner drive motor power source disconnected • Scanner HP sensor defective • Harness between SIB and HP sensor disconnected • Scanner wire, timing belt, pulley, or carriage defective
  • Code: 121
  • Description: Scanner home position error 2
    The scanner home position sensor does not detect the “ON” condition during initialization or copying.
  • Causes: • SIB or scanner motor drive board defective • Scanner motor defective • Harness between SIB and scanner drive motor disconnected • Harness between SIB and scanner drive motor power source disconnected • Scanner HP sensor defective • Harness between SIB and scanner HP sensor disconnected • Scanner wire, timing belt, pulley, or carriage defective
  • Code: 141
  • Description: Black level detection error
    The black level cannot be adjusted within the target value during the zero clamp.
  • Causes: • Defective SBU
  • Code: 142
  • Description: White level detection error
    The white level cannot be adjusted within the target during auto gain control.
  • Causes: • Dirty exposure glass or optics section • SBU board defective • Exposure lamp defective • Lamp stabilizer defective
  • Code: 143
  • Description: SBU auto adjust error
    One of the following occurred:
    • When the machine was powered on, automatic adjustment of the SBU failed.
    • Automatic white density adjustment failed when reading standard white plate.
  • Causes: • Exposure lamp defective • Lamp stabilizer defective • Lamp stabilizer connection loose, disconnected or damaged • White plate mounting is incorrect or defective • Scanner mirror or scanner lens out of position or dirty • SBU, SCNB defective • BICU (Ri10) defective • Harness connections
Error Code
Service Mode, Troubleshooting
Parts Catalog
Compatibility
Downloads Files
Home
New Register Forgot Password?
Send message to us