PrintCopy.info service

Ricoh D046 MPW5100 Be-C1

Error Codes List page 1

  • Code: SC101
  • Description: Lamp error Lamp does not light at power on.
  • Causes: If cycling the machine power off/on does not solve the problem: • Clean the white plate • Clean the CIS glass • Lamp regulator connection loose broken, defective • CIS, IPU, BCU connection loose broken defective • Harness connection between Xenon lamp and lamp regulator loose broken defective • Harness between CIS and IPU loose, broken, defective • Harness between CIS and PSU loose, broken, defective • One or more defective: CIS, IPU, BCU, PSU, Xenon lamp
  • Remedy:
  • Code: SC144
  • Description: CIS communication error A serial communication error occurred with the CIS due to a PCB malfunction or loose connection.
  • Causes: If cycling the machine power off/on does not solve the problem: • Harness between CIS and IPU loose broken defective • Harness between CIS and PSU loose, broken, defective • CIS defective • IPU defective • BCU defective
  • Remedy:
  • Code: SC161
  • Description: IPU Error Three attempts to configure the Cetus chip on the IPU board failed when the machine was switched on or when machine recovered from the energy save mode.
  • Causes: • Replace the IPU
  • Remedy:
  • Code: SC180
  • Description: Left scanner fan lock The BCU detected a left scanner fan lock signal 5 sec. after the machine was switched on.
  • Causes: If cycling the machine power off/on does not solve the problem: • Left scanner fan harness connection to the IOB loose, broken, defective • Left scanner fan defective • IOB defective • BCU defective
  • Remedy:
  • Code: SC181
  • Description: Right scanner fan lock The BCU detected a right scanner fan lock signal 5 sec. after the machine was switched on.
  • Causes: If cycling the machine power off/on does not solve the problem: • Left scanner fan harness connection to the IOB loose, broken, defective • Left scanner fan defective • IOB defective • BCU defective
  • Remedy:
  • Code: SC186
  • Description: Gray balance adjustment error
  • Causes: The value for gray balance was detected out of range after gray adjustment.
  • Remedy: If cycling the machine power off/on does not solve the problem: • Clean the white strip • Clean the CIS glass • Check the following harnesses for loose, broken, or defective connectors: 1. Xe lamp to lamp regulator 2. Lamp regulator to CIS 3. CIS to IPU 4. CIS to IPU 5. IPU to IOB • One of the following boards is defective 1. CIS 2. IPU 3. IOB 4. BCU
Error Code
Service Mode, Troubleshooting
Parts Catalog
Compatibility
Downloads Files
Home
New Register Forgot Password?
Send message to us