Causes: Replace the SDRAM DIMM if this error is frequent.
Code: 1101
Description: Data transmission did not finish within the specified time.
Causes: An incompatible loop-back connector is connected to the parallel port, or the loop-back connector is not connected. Use the correct loop-back connector (P/#: G0219350) before the test.
Code: 1102
Description: Data looped back to the controller is not the same as the data transmitted.
Causes: The loop-back connector may be defective. Try using another one.
Code: 11xx
Description: Parallel interface error.
Causes: Replace the controller if this error is frequent.
Code: 1401
Description: The controller NVRAM has a problem.
Causes: Replace the NVRAM if this error is frequent.