Description: ID sensor error 5
Vsg falls out of the adjustment target (4.0+- 0.2V) during Vsg checking.
Causes: • ID sensor defective • ID sensor connector defective • Poor ID sensor connector connection • I/O board (IOB) defective • High voltage supply board defective • Dirty ID sensor • Defect at the ID sensor pattern writing area of the drum
Code: SC360
Description: Hard disk drive error 1
The machine does not detect the connection signal from the HDD.
Causes: • Poor connection between the HDD and HDD controller board • The ac power connector to the HDD is disconnected. • HDD defective • HDD controller board defective • BICU defective
Code: SC361
Description: Hard disk drive error 2
The image data stored in the HDD cannot be output properly.
Causes: When this SC occurs only once, this problem will be solved after turning the main power switch off and on. • When this SC occurs while performing SP4-911-1 (HDD media check), it can be cured by doing SP4-911-2 (HDD formatting). • HDD defective
Code: SC362
Description: IMAC (image compression IC) error
An error occurs during image processing in the IMAC, which handles image compression and image data transmission.