OKI C6100

• Code: 918
• Display: Service call 918:Error
• Description: Duplex FANO Alarm Detection
• Causes: FAN error inside the Duplex. Is the error issued again when the power is turned on again?
• Remedy: Check to see if the Duplex is properly installed. Check to see if the FAN is properly connected. Replace the FAN.

• Code: 923
• Display: Power off/on 923:Error
• Description: Black Image Drum Lock Error
• Causes: The black image drum (K-ID) does not rotate properly. Is the error message issued again when the power is turned on?
• Remedy: Check to see if the K-ID is properly installed. Replace the K-ID. Replace the K-ID motor.

• Code: 928
• Display: Service call 928:Error
• Description: Fuser MotorLock Error
• Causes: The fuser unit does not rotate properly. Does the error reoccur after power cycling?
• Remedy: Check to see if the fuser unit is properly installed. Replace the fuser unit. Replace the fuser motor.

• Code: 980
• Display: Service call 980:Error
• Description: Error by media clinging to the fuser
• Causes: Media has clung to the fuser.
• Remedy: Power OFF Replace the fuser unit.

• Code: F0C, F0D, FFE, FFF
• Display: Power off/on 203:Error 204:Error 207:Error 208:Error 214:Error F0C:Error F0D:Error FFE:Error FFF:Error
• Description: An error was detected of the CU program. (203~214 is not occure in usual operating.)
• Causes: Reinstall the CU board. Is the error message displayed again?
• Remedy: After turn power OFF, check connections between CU board and PU board. Then turn power ON again.