Description: Overcurrent in the Y-axis motor was detected.
Remedy: 1. Check friction of Y-axis motor. 2. Replace the Y-axis motor with a new one. 3. Replace the regenerative resistance PCB with a new one. 4. Replace the main PCB with a new one.
Code: 45
Display: CAPPING : PARAMETER
Description: An error occurred in capping control. (Improper parameter adjusted value)
Remedy: 1. Make sure that the adjusting value of [#ADJUST] - [CAPPING] is set correctly.
Code: 46
Display: WIPER
Description: An error occurred in wiper control.
Remedy: 1. Check that the wiper sensor functions properly with [#TEST] - [SENSOR TEST]. 2. Check that the wiper motor functions properly with [#TEST] - [MOTOR TEST]. 3. Make sure that there is no friction on the guide rail caused by sticking of ink. 4. Replace the wiper sensor with a new one. 5. Replace the stepping motor with a new one. 6. Replace the station PCB with a new one.
Code: 50
Display: MEDIA DETECT
Description: Paper could not be detected. The media set position or media itself is not proper.
Remedy: 1. Make sure that there is no gap between the end faces of platen and platen rubber. 2. Execute [#TEST] -[PAPER SENSOR] to obtain sensor values at the media exist position and media non-exist position. When the difference of values is more than ±50, detection is allowed. If the difference is smaller, execute the followings. 3. Clean the paper width sensor or replace with a new one. 4. Replace the ink slider PCB with a new one.
Code: 51
Display: Y-ORIGIN
Description: Y-origin could not be detected.
Remedy: 1. Check that the Y origin sensor works properly with [#TEST] - [SENSOR TEST]. 2. Replace the Y origin sensor with a new one. 3. Replace the station PCB with a new one.