PrintCopy.info service

Mimaki JV3-160SP

Error Codes List page 4

  • Code: 41
  • Display: ERROR41 MOTOR Y
  • Description: • The Y-axis motor has been overloaded. • The brush of motor is in abnormal conditions.
  • Remedy: 1) Clean the main guide axis. 2) Replace Y axis motor. 3) Replace a main PCB.
  • Code: 42
  • Display: ERROR42 X CURRENT
  • Description: • Overcurrent error has arisen on the X-axis motor
  • Remedy: 1) Replace X axis motor. 2) Replace a main PCB.
  • Code: 43
  • Display: ERROR43 Y CURRENT
  • Description: • Overcurrent error has arisen on the Y-axis motor
  • Remedy: 1) Replace Y axis motor. 2) Replace a main PCB.
  • Code: 46
  • Display: ERROR46 WIPER
  • Description: • The wiper-control is in abnormal conditions.
  • Remedy: 1) Turn on the power. 2) Replace a wiper assy. 3) Replace IO PCB. 4) Replace a wiper sensor. 5) Replace a wiper motor.
  • Code: 50
  • Display: ERROR50 MEDIA SENSE
  • Description: • Media detection has not been successfully carried out.
  • Remedy: 1) Make sure that there is no gap between platen F (aluminum) and the edge of the P cover F rubber. If there is a gap, stick the rubber appressed against the platen. The gap may be detected in mistake. 2) Make sure that platen cover F is fixed securely using the platen cover F mounting screws (attached on auxiliary side plates R and L to prevent the cover from protruding). 3) Check if the media right edge is set at a position 15mm or more from the rightmost edge of the rightmost feed roller:R1 toward the station side or not. 4) Cleaning or replace a paper width sensor. 5) Replace a HDC FPC cable. 6) Replace a slider PCB. 7) Replace a main PCB.
  • Code: 51
  • Display: ERROR51 Y ORIGIN
  • Description: • Y-axis origin detection has not been successfully carried out.
  • Remedy: 1) Replace a Y axis motor. 2) Replace a Y origin sensor. 3) Replace a IO PCB. 4) Replace a main PCB.
Error Code
Service Mode, Troubleshooting
Parts Catalog
Compatibility
Downloads Files
Home
New Register Forgot Password?
Send message to us