Remedy: The REMOTE key was pressed at power on and the system was set to version upgrade mode. 1. This is not an error, so no action is needed. 2. When the user touches the key carelessly, this message prompts the user to shut power down and restart the system. This message appears every time the system is started (malfunction in the keyboard PCB assembly). Replace the keyboard PCB assembly.
Code: n26
Display: REMOTE & COPY
Description: Remote display when no. of copies has been set
Causes: This message appears when Remote Mode is activated with the number of copies set to 2 or larger in the registration mark detection setting.
Remedy: No action is needed if copying is performed at the end of cutting. This message is designed to prevent unintended copy operation when the user neglected to alter settings after the previous copying operation.
Code: n27
Display: UP & DOWN READY
Description: Parameter Upload/Download Mode
Causes:
Remedy: The or key was pressed at power on and the system was set to version upgrade mode. 1. This is not an error, so no action is needed.. Perform parameter upload or download operation. 2. When the user touches the key carelessly, this message prompts the user to shut power down and restart the system. This message appears every time the system is started (malfunction in the keyboard PCB assembly). Replace the keyboard PCB assembly.
Code: n28
Display: SKIP COUNT:
Description: Copy skip was activated
Causes:
Remedy: REMOTE and SKIP CNT appear alternately during continuous copy operation. Skip occurred during copy operation and the number is displayed. No action is needed as this is only a status display. This message appears at the end of copying operation and nothing happens. Skip occurred during copy operation and the number is displayed at the end of the operation. Press any key to revert to the normal remote display.
Code: n29
Display: !OPT-SENSOR OFF
Description: Coupler sheet sensor is not responding
Causes: The system is pausing as No Sheet was detected by the sheet sensor during continuous copying operation with the optional coupler unit.
Remedy: This is not an error, so no action is needed. If you do not plan to use the coupler, switch it OFF to disable it. You can also press the END key to temporarily disable the sensor and to continue the current operation. Note that the print may be damaged if this action is taken while printing and cutting.
Code: n30
Display: WINDING START
Description: Displayed during winding operation
Causes: This message appears while the winder is winding sheet.
Remedy: This is not an error, so no action is needed.