Remedy: 1 If the IC-412 is not mounted, access [Service Mode] - [System 2] - [Image Controller Setting] and check to see if gController 0h is set for [Image Controller Setting]. . . 2 Check the relay board (VI-505) connector for proper connection and correct as necessary. . . 3 Change relay board (VI-505). . . 4 Change MFPB.
Code: CD261
Description: USB host board failure
Causes: MFP board (MFPB) USB host board (EK-604)
Remedy: 1 Check the operation with another USB device. - - 2 Check the USB host board connector for proper connection and correct as necessary. - - 3 Change USB host board. - - 4 Change MFPB.
Code: CD271
Description: i-Option activated and additional memory not installed
Causes: MFP board (MFPB) Memory for i-Option (UK-203)
Remedy: 1 Check the memory (UK-203) for proper connection and correct as necessary. - - 2 Change memory (UK-203). - - 3 Change MFPB.
Code: CD272
Description: i-Option activated and additional memory and HDD not installed
Causes: MFP board (MFPB) Hard disk Memory for i-Option (UK-203)
Remedy: Check the memory (UK-203) for proper connection and correct as necessary. - - 2 Check the HDD for proper connection and correct as necessary. - - 3 Change memory (UK-203). - - 4 Change HDD - - 5 Change MFPB.
Code: CD3##
Description: NVRAM data error
Causes:
Remedy: . When the data stored due to the NVRAM trouble is lost, backup data can be used for restoration. . Trouble code [C-D370] will be displayed when multiple errors (over 5) of NVRAM data are detected, which can be restored with one restoration command. . Data backup will be automatically performed every hour. Backup can also be performed manually with the following setting. [Service Mode] - [Enhanced Security] - [NVRAM Data Back Up] 1. When a trouble caused by NVRAM data error occurs, the screen below appears. 2. Select [Yes] and touch [OK]. 3. The screen will be shifted to the data restoration screen to perform data restoration. NOTE • When the restoration is performed in a short time, data restoration screen may not be displayed. 4. Check the message which indicates that the data restoration was successfully conducted. Turn OFF the main power switch and turn it ON again more than 10 seconds after. NOTE • In case it failed to restore data, return to the trouble code screen.
Remedy: 1 Check whether there is an strong electromagnetic noise source near the main body. - - 2 Check the connectors on MFPB for proper connection and correct as necessary. - - 3 Change MFPB.