Causes: • PF control board (PFCB) • Controller board (CTLB)
Remedy: 1 Check all connections to PFCB. Reseat the cables if any abnormality is found. 2 Check printer’s firmware level. Rewrite the firmware if any abnormality is found. 3 Replace the tray 2. 4 Replace CTLB.
Code: 0204-325.63
Description: Tray 2 feeder up/down abnormality
Hardware error - Sensors are not plugged on the board
Causes: • PF control board (PFCB) • Controller board (CTLB)
Remedy: 1 Check all connections to PFCB. Reseat the cables if any abnormality is found. 2 Check printer’s firmware level. Rewrite the firmware if any abnormality is found. 3 Replace the tray 2. 4 Replace CTLB.
Code: 0206-331.51
Description: Tray 3 lift-up failure
ACM motor no first encoder
Causes: • ACM motor • PF control board (PFCB)
Remedy: 1 Remove the option tray insert. 2 Check the lift plate and gears for proper operation by moving the metal plate. Replace the tray 3 if any abnormality is found. 3 Check the ACM motor for the following: • Gear tooth breakage • Freedom of rotation Replace the tray 3 if any abnormality is found. 4 Check the cable J11 on PFCB. Replace the tray 3 if any abnormality is found.
Code: 0206-331.52
Description: Tray 3 lift-up failure
ACM motor stop error
Causes: • ACM motor • PF control board (PFCB)
Remedy: 1 Remove the option tray insert. 2 Check the lift plate and gears for proper operation by moving the metal plate. Replace the tray 3 if any abnormality is found. 3 Check the ACM motor for the following: • Gear tooth breakage • Freedom of rotation Replace the tray 3 if any abnormality is found. 4 Check the cable J11 on PFCB. Replace the tray 3 if any abnormality is found.
Remedy: 1 Remove the option tray insert. 2 Check the lift plate and gears for proper operation by moving the metal plate. Replace the tray 3 if any abnormality is found. 3 Check the ACM motor for the following: • Gear tooth breakage • Freedom of rotation Replace the tray 3 if any abnormality is found. 4 Check the cable J11 on PFCB. Replace the tray 3 if any abnormality is found.
Code: 0206-332.54
Description: Tray 3 lift-up failure
Separator/Pass-through motor - Motor no first encoder
Causes: • PF control board (PFCB) • Separator roll assembly
Remedy: 1 Remove the option tray insert. 2 Check the separator roll assembly gear under the tray base for the following: • Gear tooth breakage • Freedom of rotation Replace the tray 3 if any abnormality is found. 3 Check the cable J10 on PFCB. Replace the tray 3 if any abnormality is found. 4 Check the separator roll assembly for wear or damage. Replace the separator roll assembly if any abnormality is found.