Remedy: 1. Verify that the power cord is correctly connected and the power switch is ON. 2. Verify that the electrical outlet is on. 3. Check for a blown fuse or open circuit on the unit’s internal power supply. 3. Check the DC output voltages from the power supply unit to connector P3 on the main control PCB. If any of the following voltages are incorrect, replace the power supply. • Pin 4, 5 : +5 V • Pin 8, 9 : +3.3 V • Pin 6, 7, 10, 11, 14, 15 : GND • Pin 12, 13 : +24 V@Pin 1:5 V • Pin 12, 13 : +17 V@Pin 1:0 V
Code: D.0.2
Description: The remote unit is busy. Try the call again.
Remedy:
Code: D.0.3, D.0.8
Description: The remote unit didn’t respond, the call couldn’t be completed or stop was pressed uring dialing. Retry the call. If your machine repeats the message, call the remote fax unit’s operator and verify that unit is operating properly.
Remedy:
Code: D.0.6, D.0.7
Description: Either the remote unit didn’t respond, the call somehow didn’t go through or STOP was pressed during dialing. Try the call again.
Remedy:
Code: R.1.1
Description: T1 time-out. The calling unit was not a fax machine or the transmitting unit is having difficulties.
Remedy:
Code: R.1.2
Description: The two fax machines were incompatible. Your machine sends and receives only ITU-T Group 3 fax communication, the industry standard since the early 1980s.