Description: The data in the print job is too complex.
Remedy: 1. Press the OK button to print the transferred data (some data might be lost). 2. If this message displays often, simplify the print job or install more memory.
Code: 22
Display: 22 EIO X BUFFER OVERFLOW
Description: Too much data was sent to the EIO card in the specified slot [X]. An improper communications protocol might be in use. Note: EIO 0 is reserved for the HP Jetdirect embedded print server
Remedy: 1. Press the OK button to clear the message. (The job does not print.) 2. Check the host configuration. If the message persists, contact an HPauthorized service or support provider.
Code: 22
Display: 22 EMBEDDED I/O BUFFER OVERFLOW
Description: Too much data was sent to the product's internal HP Jetdirect.
Remedy: Press the OK button to continue printing. Some data might be lost.
Code: 22
Display: 22 USB I/O BUFFER OVERFLOW
Description: Too much data was sent to the USB port.
Remedy: Press the OK button to clear the error message. (The job does not print.)
Code: 40
Display: 40 EIO X BAD TRANSMISSION
Description: The connection has been broken between the product and the EIO card in the specified slot [X]. Note: EIO 0 is reserved for the HP Jetdirect embedded print server.
Remedy: Press the OK button to clear the error message and continue printing.
Code: 40
Display: 40 EMBEDDED I/O BAD TRANSMISSION
Description: The connection has been broken between the product and HP Jetdirect print server.
Remedy: 1. Print the configuration and Embedded JetDirect pages to verify that the card status is “Ready,” and that the protocol reads “Ready.” 2. Verify that all the configuration parameters (IP address, configuration method, and domain) are correct. 3. Verify that you are using a working network cable. 4. Verify you can “ping” a network address from the product. 5. Verify that the HP JetDirect print server has the latest firmware. HP JetDirect firmware is part of the product firmware.